Cirrus Logic 5446 Graphics Controller - Compaq DESKPRO 2000 SERIES Maintenance & Service Manual

5.2.10.2 Cirrus Logic 5446 Graphics Controller

To install additional memory onto the Cirrus Logic 5446 Graphics Controller board, complete the
following steps:
1. Perform preparation procedures described in section 5.2.3.
2. Remove the access panel (section 5.2.6.1).
3. Remove the expansion board (Section 5.2.8).
4. Place the graphics board on a flat surface and install the upgrade module.
Ensure that all pins on the connector are properly aligned to avoid damaging the memory module
and/or the graphics controller.
If you are removing a memory module, rock the module gently while pulling it up.
Figure 5-67. Installing a Memory Upgrade Module on the Cirrus Logic Graphics Board
5-72 Removal and Replacement Procedures