Led Cable - Compaq DESKPRO 2000 SERIES Maintenance & Service Manual

5.1.21 LED Cable

To remove the LED cable, complete the following steps:
1. Perform the preparation procedures described in Section 5.1.3.
2. Remove the access panel (Section 5.1.6).
3. Remove the riser brace (Section 5.12).
4. Disconnect the cable from the connection on the system board.
Figure 5-53. Removing the LED Cable From the Pentium (Top) and Pentium Pro (Bottom) System Boards
The connector is keyed to ensure proper installation.
Compaq Deskpro 2000 5-57