Compaq DESKPRO 2000 SERIES Maintenance & Service Manual page 164

5. Place the 3.5-inch drive into the bracket.
6. Insert two screws into the bracket holes on each side of the bracket to secure the drive.
Figure 5-46. Placing the Hard Drive and Inserting Four Screws into the Bracket
CAUTION: Use only 3/16-inch or 5-mm long screws as guide screws. Longer screws
can damage the internal components of the drive.
7. Install two wafer screws from step 1. Insert one on each side of the bracket. These are guide screws
are used to align the bracket in the drive bay.
Figure 5-47. Inserting Two Flanged Screws into the Bracket
8. Install the drive assembly into the drive bay positioning the guide screws into the tabs on either side
of the drive bay.
Compaq Deskpro 2000 5-51