Bezel Blank - Compaq DESKPRO 2000 SERIES Maintenance & Service Manual

5.2.17.3 Bezel Blank

To remove the bezel blank, complete the following steps:
1. Perform the preparation procedures described in Section 5.2.3.
2. Remove the access panel as described in Section 5.2.6.1.
3. Remove the front bezel as described in Section 5.2.17.1.
4. Lay the front bezel face down on a protected work surface and remove
the two screws that secure the bezel blank to the bezel.
5. Remove the bezel blank from the front bezel.
Figure 5-84. Removing the Bezel Blank
To replace the bezel blank, reverse the above procedures.
Compaq Deskpro 2000 5-93