Removing A Drive From The Drive Cage - Compaq Deskpro Workstation AP240 Reference Manual

Removing a Drive
from the Drive Cage
10. Reconfigure the workstation, if necessary. Refer to Chapter
2, "Software," for more information.
If you have installed a second diskette drive (B), you will
need to reconfigure the workstation, using Computer
Setup, to recognize the B drive. Choose the
Storage/Diskette Drives option, to enable the drive and
select the drive size.
11. If you normally lock the Smart Cover Lock, use Computer
Setup to relock the lock and enable the Smart Cover
Sensor.
1. If you have locked the Smart Cover Lock, use Computer
Setup to unlock the lock and disable the Smart Cover
Sensor.
2. Shut down the operating system properly, turn off the
workstation, disconnect the power cord from the
electrical outlet, and remove the workstation cover.
3. Grasp the top of the tilt drive cage and rotate it to its
upright position.
4. Disconnect the drive power and signal cables and, if it is
a CD-ROM drive, disconnect the audio connector.
CAUTION:
Before completing the following step, note that the
drive slides easily out of the drive cage. Do not allow the drive to
strike a hard surface as it exits the drive cage. Excessive shock can
damage the drive.
Reference Guide 5-25