To install an inboard expansion board, complete the following steps:
1. Slide the expansion board into the expansion slot and press it firmly into place.
2. Replace the retainer bracket and the retaining screw.
Figure 5-12. Replacing the Retainer Bracket and the Retaining Screw
3. Replace the system unit cover.
4. To reconfigure the computer to recognize the added expansion board, run the Computer Setup utility
to reconfigure the system. Refer to Chapter 7, "Compaq Utilities."
5. Test the computer (optional) using the Computer Checkup (TEST) utility. Refer to Chapter 2,
"Troubleshooting."
5-14
Removal and Replacement Procedures