5. If you are installing a 3.5-inch diskette drive, use bracket number 243230-001 which comes with a
preinstalled bezel. This bracket is available from your Compaq dealer or service provider.
If you are installing a 3.5-inch hard drive, use bracket number 243231. This bracket is available from
your Compaq dealer or service provider.
6. Place the 3.5-inch drive into the bracket.
7. Insert two screws into the bracket holes on each side of the bracket to secure the drive.
Figure 5-98. Placing the Hard Drive and Inserting Four Screws into the Bracket
8. Install one high hat screw from step 1. Insert the screw on the right side of the bracket. This screw is
used to align the bracket in the drive bay.
Figure 5-99. Inserting the High Hat Screw into the Bracket
5-108
Removal and Replacement Procedures