5.1.18.1 3.5-Inch Wide Drive Bays
The computer has two 3.5-inch third-height drive bays, one of which is occupied by the diskette drive.
To remove a 3.5-inch drive from the 3.5-inch wide drive bay, complete the following steps:
1. Perform preparation procedures described in Section 5.1.3.
2. Remove the system unit cover (Section 5.1.6).
3. Remove the front bezel (Section 5.1.15.1).
4. Disconnect the interconnect cables from the back of the drive.
Figure 5-37. Disconnecting the Signal and Power Cables from the 3.5-Inch Diskette Drive
5-42
Removal and Replacement Procedures