Installing a Hard Drive in the Removable
Hard Drive Cage (Bays 1 - 3)
The removable hard drive cage is capable of being configured with up to three
1.0-inch hard drives or with two 1.6-inch hard drives. Other than using different
screw holes, the installation for both drives is basically the same.
NOTE: Prior to installing a SCSI device, please read "SCSI Cables and
Guidelines" later in this chapter.
To install a 1.0-inch hard drive in the removable hard drive cage:
1.
Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2.
Remove the side access panel and the removable hard drive cage.
3.
Remove four screws (top group of screws) from the air plenum located
at the front of the workstation.
4.
Refer to the following illustrations to install an optional hard drive.
Figure 8-15. Installing a 1.0-inch hard drive in bay 2
Writer: Jeff Parmenter Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-002
File Name: I-CH08.DOC Last Saved On: 2/11/99 8:29 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Compaq Professional Workstation AP500 Reference Guide
8-13