Compaq DESKPRO 2000 SERIES Maintenance & Service Manual page 224

12. Remove the bezel blank from the front bezel (Section 5.2.17.3).
13. Install the front bezel.
14. Install the access panel.
15. The system will automatically recognize a hard drive sold by Compaq and will automatically
reconfigure the computer. If you have installed a third party hard drive, you will need to run
Computer Setup to reconfigure the computer. Refer to Chapter 7, " Compaq Utilities," for
information on running Computer Setup.
16. Test the system (optional) using the Computer Checkup (TEST) utility. Refer to Chapter 2,
"Troubleshooting."
The figure below illustrates the recommended ribbon cable position for the CD-ROM drive.
Figure 5-102. Ribbon Cable Position for the CD-ROM Drive
Compaq Deskpro 2000 5-111