Screen Position Adjustment - Canon iR3245 Series Service Manual

- Test print will be output.
6) By following the control panel screen, place the test print on the copy-
board glass.
7) Close the platen cover/DADF.
8) Press [Start Scan].
- Test print will be scanned.
- 'Auto gradation Adjust is finished' will be displayed.
9) Remove the test print from the copyboard glass.
10) Exit the [Additional Functions].

2.2.13 Screen Position Adjustment

iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
"2nd side on 2-sided print" used below means the 2nd side at image
formation.
With the host machine, 2nd side on 2-sided copy/print at image formation
is corresponding to the 1st side of originals.
1. Left Marge adjustment (1st side)
Make a copy from cassette 1, 2 and manual pickup feed unit, and check that
the left margin is within 2.5 +/- 1.5mm.
[1]
[1] paper feed direction
<If the cassette 1 or 2 is out of standard>
1) Open the cassette upper right cover [1]. If the cassette feeding unit is in-
stalled, open the cassette lower right cover [2].
[1]
2) Remove the right cover (lower front) [1].
- 2 screws [2]
image
F-2-59
[2]
F-2-60
0019-4005
3) Remove the cassette 1 or 2.
4) Check the position [1] of the scale on the adjustment plate.
A. Adjusting the cassette 1.
A-1) Disengage the 2 claws [1] and remove the grip (front right) [2] in the
direction of the arrow.
A-2) Loosen one fixing screw [2] on the adjustment plate [1].
A-3) Move the adjustment plate back or forth in reference to the scale
checked by step 4). Moving the adjustment plate toward rear of the host
machine increases the left margin.
Chapter 2
[2]
[1]
F-2-61
F-2-62
F-2-63
2-15