Canon iR3245 Series Service Manual page 97

After replacing the AC driver PCB
[1]
[5]
[3]
[2]
[3]
[5]
[4]
13) Connect the connector for the cassette heater that is situated near the AC
driver PCB and is connected to the host machine to J482 [1] of the AC
driver PCB.
- 1 edge saddles [2]
- 1 wire saddles [3]
Connect the connector for the DC controller that is situated near the AC
driver PCB and is connected to the host machine to J486 [4] of the AC
driver PCB.
[2]
[3]
[4]
14) Insert the protrusion [2] of the environment switch unit into the host ma-
chine frame hole [1] and install the environment switch unit [4] with the
screw (TP; M3X6) [3].
[4] [2]
[5]
F-2-114
[1]
F-2-115
[5]
[3]
[2]
[5]
15) Connect the connector [1] of the environment switch unit to J483 of the
AC driver PCB.
- 1 reuse band [2]
- 1 wire saddles [3]
- 1 edge saddles [4]
[1]
[2]
[3]
16) Install the lower rear cover.
17) Install the upper rear cover.
18) Connect the lattice connector to the host machine.
19) Connect the host machine's power plug to the outlet, and then turn ON
the main power switch.
20) Turn on the environment heater switch.
21) Install the environment heater switch cover.
2.10 Installing the Cassette Heater for the
[3]
[1]
[4]
[2]
F-2-116
[4]
F-2-117
Chapter 2
2-29