Image Position Adjustment - Canon imageRUNNER ADVANCE C2030 Series Manual

Image Position Adjustment

■ Left Edge Margin Adjustment (1st side)
Adjustment of Cassette/Manual feed pickup tray
Print from each cassette/Manual feed pickup tray, and check that the left edge margin of the
image (L1) is within 2.5 +/- 1.5mm.
If it is not within the range, execute adjustment by following the procedure below.
Feeding direction
of paper
1) Adjust the image position in service mode.
Cassette 1: Service mode (Level 2) > COPIER > ADJUST > MISC > C1-ADJ-Y
Cassette 2: Service mode (Level 2) > COPIER > ADJUST > MISC > C2-ADJ-Y
Cassette 3: Service mode (Level 2) > COPIER > ADJUST > MISC > C3-ADJ-Y
Cassette 4: Service mode (Level 2) > COPIER > ADJUST > MISC > C4-ADJ-Y
Manual feed pickup tray: Service mode (Level 2) > COPIER > ADJUST > MISC > MF-
ADJ-Y
NOTE:
<Setting Range>
-128 to 127 (0.1mm per unit)
As the value is incremented by 1, the left edge margin is increased by 0.1mm.
2) Print from the cassette/manual feed pickup tray, and check that the left edge margin of the
image is within 2.5 +/- 1.5mm.
3) When the setting value was changed in step 1), write down the new numerical value in the
service label.
4) Exit from the service mode.
image
F-1-36
■ Left Edge Margin Adjustment (2nd side)
NOTE:
By executing the margin adjustment (2nd side) for the Cassette 1, the adjustment is
applied to all source of paper.
Execute duplex printing from the Cassette 1, and check that the left edge margin is within 2.5
+/- 2.0mm.
If it is not within the range, execute adjustment by following the procedure below.
Feeding direction
of paper
1) Adjust the image position in service mode.
Service mode (Level 1) > COPIER > ADJUST > FEED-ADJ > ADJ-REFE
NOTE:
<Setting Range>
-128 to 127 (0.1mm per unit)
As the value is incremented by 1, the left edge margin is increased by 0.1mm.
2) Execute duplex printing from the Cassette 1, and check that the left edge margin is within 2.5
+/- 2.0mm.
3) When the setting value was changed in step 1), write down the new numerical value in the
service label.
4) Exit from the service mode.
14
image
F-1-37
14