Canon iR3245 Series Service Manual page 109

4) Insert the voice board unit [1] into the connector [2] on the main controller
PCB, and then install it.
- 2 screws [3] (that have been removed in step 2)
- 2 screws (TP; M3X6) [4]
[2]
[1]
5) Remove the screw [2] and the face seal [3] at the reader right cover [1].
(Do not use the removed screw and the face seal.)
[1]
F-2-171
[4]
F-2-172
[2] [3]
6) Install the speaker unit (lower) [1].
- 1 screw (binding; M3X16) [2]
- 1 screw (binding; M4X16) [3]
[2] [3]
[3]
7) Install the speaker unit (upper) [1] to the speaker unit (lower).
- 1 screw (binding; M4X6) [2]
[3]
8) Remove the cover [1] of the cable guide.
9) Remove the release paper of the cable guide [1] and install the cable guide.
A: In the case that the card reader has not been installed on the host
machine
<Right side - 2 locations>
[1]
F-2-173
[1]
F-2-174
[1]
[2]
F-2-175
[1]
F-2-176
Chapter 2
2-41