Before Removing The Main Motor (Ir 3225); Removing The Main Motor (Ir 3225); Fixing Driver Motor; Removing The Fixing Driver Motor - Canon iR3245 Series Service Manual

[1]
[2]
Adjusting the Tension of the Main Motor
1) Temporarily fix the main motor mounting plate in place to the main drive
unit.
2) So that the motor gear and the teeth of the pulley mesh correctly, move
the motor in the direction of the arrow.
3) Tighten the screws of the main motor mounting plate in the order indicated
([A] -> [B] -> [C] -> [D]).
[B]
[C]

10.5.20.3 Before Removing the Main Motor (iR 3225)

iR3225 / iR3225N
1) Remove the upper rear cover. (page 10-17)Reference[Removing the
2) Remove the lower rear cover. (page 10-17)Reference[Removing the

10.5.20.4 Removing the Main Motor (iR 3225)

iR3225 / iR3225N
1) Remove the main motor [3].
[2]

10.5.21 Fixing Driver Motor

10.5.21.1 Removing the Fixing Driver Motor

iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
(Perform the same procedure from step 1 to 2 as in 'Removing the DC Con-
troller PCB'.) (page 10-27)Reference[Removing the DC Controller PCB]
1) Remove the DC controller PCB mounting plate [3].
[D]
[A]
0019-8358
Upper Rear Cover]
Lower Rear Cover]
- 1 connector [1]
- 4 screws [2]
[2]
[3]
F-10-102
- 6 wire saddles [1] (removing the harness)
- 3 edge saddles [2] (removing the harness)
- 13 connectors [4]
- 4 screws [5]
[5] [3] [4]
[2]
[4]
[1]
[4]
[5]
F-10-103
Chapter 10
[1]
[2]
[1] [2]
[5]
[4]
[1]
[5]
[2]
10-35
0019-8360
0018-9969