Canon iR3245 Series Service Manual page 574

Chapter 17
Item Level
C1-ADJ-Y 2
C2-ADJ-Y 2
C3-ADJ-Y 2
C4-ADJ-Y 2
17-76
COPIER > ADJUST > MISC
Description
Title Cassette 1 side registration adjustment value entry
Purpose - In case of adjusting side registration of paper picked up from cassette 1
- When executing RAM clear of DC controller PCB/replacing the PCB (enter the value on service
label)
Note Note the value on service label after adjusting this mode
Settings/Adjustment range -128 to +127
Unit mm
Amount of change per unit 0.1
Value at RAM clear/ 0/No
adjustment at factory
shipment
Setting/Adjustment/Operation 1) Select the item to be highlighted to enter the setting value (switch with +/- key), and then press OK
method key.
2) Turn OFF and then ON the main power switch.
The front margin becomes bigger by 0.1mm with 1-increment in the value
Relevant Service Mode -
Supplementary info/Memo Enter the value according to the registered numeric figure for laser scan-start position with paper
picked up from cassette 1
Title Cassette 2 side registration adjustment value entry
Purpose - In case of adjusting side registration of paper picked up from cassette 2
- When executing RAM clear of DC controller PCB/replacing the PCB (enter the value on service
label)
Note Note the value on service label after adjusting this mode
Settings/Adjustment range -128 to +127
Unit mm
Amount of change per unit 0.1
Value at RAM clear/ 0/No
adjustment at factory
shipment
Setting/Adjustment/Operation 1) Select the item to be highlighted to enter the setting value (switch with +/- key), and then press OK
method key.
2) Turn OFF and then ON the main power switch.
The front margin becomes bigger by 0.1mm with 1-increment in the value
Relevant Service Mode -
Supplementary info/Memo Enter the value according to the registered numeric figure for laser scan-start position with paper
picked up from cassette 2
Title Cassette 3 side adjustment registration value entry
Purpose - In case of adjusting side registration of paper picked up from cassette 3
- When executing RAM clear of DC controller PCB/replacing the PCB (enter the value on service
label)
Note Note the value on service label after adjusting this mode
Settings/Adjustment range -128 to +127
Unit mm
Amount of change per unit 0.1
Value at RAM clear/ 0/No
adjustment at factory
shipment
Setting/Adjustment/Operation 1) Select the item to be highlighted to enter the setting value (switch with +/- key), and then press OK
method key.
2) Turn OFF and then ON the main power switch.
The front margin becomes bigger by 0.1mm with 1-increment in the value
Relevant Service Mode -
Supplementary info/Memo Enter the value according to the registered numeric figure for laser scan-start position with paper
picked up from cassette 3
Title Cassette 4 side registration adjustment value entry
Purpose - In case of adjusting side registration of paper picked up from cassette 4
- When executing RAM clear of DC controller PCB/replacing the PCB (enter the value on service
label)
Note Note the value on service label after adjusting this mode
Settings/Adjustment range -128 to +127
Unit mm
Amount of change per unit 0.1
Value at RAM clear/ 0/No
adjustment at factory
shipment
Setting/Adjustment/Operation 1) Select the item to be highlighted to enter the setting value (switch with +/- key), and then press OK
method key.
2) Turn OFF and then ON the main power switch.
The front margin becomes bigger by 0.1mm with 1-increment in the value
Relevant Service Mode -
Supplementary info/Memo Enter the value according to the registered numeric figure for laser scan-start position with paper
picked up from cassette 4