Chapter 2
[2]
[2]
8) Install the 4 cord guide covers [1].
[1]
9) Connect the cable [1] of the MFP antenna to the terminal [2] of the wire-
less LAN board.
[2]
2-50
[1]
[2]
F-2-215
[1]
F-2-216
[1]
F-2-217
10) Insert the power plug into the power outlet.
11) Turn on the main power switch.
12) Check to see that the wireless LAN board is recognized.
Enter service mode.
COPIER > DISPLAY > ACC-STS > PCI to 2
hen 'Wireless LAN Board' is displayed, the wireless LAN board is
correctly recognized.
2. User data list output
Output the user data list in order to check that the wireless LAN has been rec-
ognised.
1) Select: [Additional Functions] > [Report Settings] > [Extension Card] in
the Print List > [User Data List].
2) After a message is displayed, select 'Yes' to output the user data list.
2.17.5 Attaching the Label
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
1) Attach the Wireless LAN display label[1] as shown in the figure.
2.18 Installing the IPSec Board
2.18.1 Notice At Installation
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
Install this equipment after installing the Expansion Bus.
2.18.2 Checking the Contents
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
<IPSec Board-A1>
[1]
[1]
IPSec Board
[2]
IP board support plate
[3]
Screw (TP; M3X6)
2.18.3 Turning OFF the Power of the Host Machine
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
Be sure to refer to "Points to Note When Turning OFF the Main Power" in
installation of the host machine.
2.18.4 Installation Procedure
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
[1]
F-2-218
[2]
F-2-219
1pc.
1pc.
2pc.
0019-0034
0019-4593
0018-8186
[3]
0018-8187
0018-8184