Adjustment Throttle Cable; Idle Adjustment - Husqvarna 2013 TC 250R Workshop Manual

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
5
4
4
1
5
1
SETTINGS AND ADJUSTMENTS

Adjustment throttle cable

To check the correct adjustment of the throttle operate as follows:
- Remove rubber caps (1);
2
- By moving the opening cable (2) back and forth, check that free play is 3
mm;
- By moving the closing cable (3) back and forth, check that free play is 1 mm;
- If it does not happen, loosen the nut (4) and appropriately turn the adjuster
screw (5);
(loosen it to decrease clearance, tighten it to increase it);
3
- After adjustment block the nut (4).
Operation with damaged throttle cable could result in an unsafe
H11275
riding condition.
Exhaust gas contains poisonous carbon monoxide. Never run the
engine indoors.
To replace the cables, you will need to remove the fuel tank as described in the
relevant paragraph.

Idle adjustment

Adjust the carburetor with warm engine and with the throttle control in closed
position. Proceed as follows:
- turn the knob (1) on the right side of the throttle body of about 34 clicks from
the fully closed position, checking with the suitable device that revs are of
about 1,950 RPM (turn clockwise to increase the speed and counter clockwise
to reduce it).
H11276
D.9
Workshop Manual Ed. 07-2012