Husqvarna 2013 TC 250R Workshop Manual page 193

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
7
8
8
9
10
10
11
ENGINE REASSEMBLY
Check the bearings of the timing drive upper gear (7) and replace them if needed.
The gear (7) requires no timing.
Refit the gear (7) with its shaft (8) and gasket (9).
Grease the O-Ring (9) before refitting the shaft (8). Check the status
of the gasket (9) and if it shows damages, replace it.
H11349
H11350
Tighten the screws (10) with a Phillips screwdriver (4 Nm, 0.4Kgm, 2.9 ft/lb,
Loctite 243).
H11351
Tighten the drilled bolt (11) using a 12 mm wrench at a torque of 8 Nm, 0.8
Kgm, 5.9 ft/lb.
H11352
H.45
Workshop Manual Ed. 07-2012