Husqvarna 2013 TC 250R Workshop Manual page 196

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
A
Workshop Manual Ed. 07-2012
ENGINE REASSEMBLY
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
Clean the mount and tighten the screws (A) with a fitting sequence from 7 to 14
as the diagram "B" shows. Initially tighten them with a 7 Nm - 0.7 kgm - 5.16 ft/lb
A
pre-tightening torque, then with a 11 Nm - 1.1 kgm - 8.11 ft/lb tightening torque.
A
Diagram "B"
A
H11076
10
Turn the crankshaft manually a few turns to check for free, smooth rotation without
any tight points, then bring it back to Top Dead Centre position.
Check the valve clearance as outlined in Chapter "D".
Grease the O-Ring gasket (7) then refit the spark plug recess (8) making sure
that the gasket does not get damaged.
7
H11077
8
H11078
13
8
12
H.48
11
9
7
14
H11152