NUDA 900 2012/2013 - NUDA 900 R 2012/2013
1
1a
1
2
1
2 mm
(0,08 in.)
2
SETTINGS AND ADJUSTMENTS
Side panel removal
-
Remove the saddle as described in the relevant paragraph.
-
Loosen the five screws (1) and remove the right-hand side (2).
-
Perform the same procedures for the removal of the left-hand side.
During the reassembly, tighten the screws with the respective
bushings, and position the M6 screw (1a) in the centre part of the
side.
1
H10669
Throttle cable adjustment
To check the correct adjustment of the throttle control cable, operate as follows:
-
remove the reservoir and the filter box as outlined in the relevant sections;
- turn throttle twistgrip (1) and make sure that there is a clearance of approx.
2 mm (0.08 in);
-
if this does not work, unlock the check nut (2);
-
work on the nut (3) until you have about 2 mm clearance (0.08 in.);
- tighten check nut (2).
- reassemble all parts, in the reverse order compared to disassembly.
Operation with damaged throttle cable could result in an unsafe
riding condition.
H10670
When throttle control cables (4) are replaced, adjust new cables as previously
explained.
3
4
H10906
D.5
Workshop Manual Ed. 11-2011