Flywheel Cover Installation - Husqvarna 2013 TC 250R Workshop Manual

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
3
2
4
4
5
3
2
ENGINE REASSEMBLY
TXC 250R - 310R 2013 I.E. USA

Flywheel cover installation

TE-TXC
Install the stator (1) with its mark lined up with the flywheel cover mark and
tighten the retaining screws (2) (use an Allen wrench; for TC use a 4 mm, 4 Nm,
0,4 Kgm, 2.95 ft/lb + Loctite 272; for TE-TXC use a 5 mm, 6 Nm, 0,6 Kgm, 4.43
4
ft/lb + Loctite 272).
Insert the cable guide (3) into its seat in the cover and tighten the two retaining
5
screws (4) of the pick-up sensor (5) with its plate (6 Nm, 0.6 Kgm, 4.3 ft/lb +
Loctite 272).
4
Install the flywheel cover (7) with its gasket and tighten the six screws (8) to 6
2 Nm, 0.6 Kgm, 4.3 ft/lb.
Make sure the two centring bushings (6) are in place.
1
H11079
TC
2
1
H11080
TE-TXC
8
8
H11081
H.49
TC
8
7
8
H11082
Workshop Manual Ed. 07-2012