Ignition And Starter System (Tc) - Husqvarna 2013 TC 250R Workshop Manual

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
1
14
15
Key to wiring diagram
1. Electronic control unit
2. Control unit interface
3. Engine stop
4. Not used
5. Coil / Stick coil
6. Map change connector
Workshop Manual Ed. 07-2012
ELECTRICAL SYSTEM
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA

Ignition and starter system (TC)

The engine injection and starter system is controlled by the control unit (ECU);
by means of a series of sensors, the ECU controls the status of the engine and
of the surrounding environment at each given moment.
The sensors are: a crankshaft position sensor (pick-up), a temperature sensor
of the filter box ambient air, a coolant temperature sensor, a throttle position
sensor and a pressure sensor on the throttle body.
13 12
7. Voltage regulator
8. Alternator
9. Fuel pump
10. Condenser
11. Injector
12. Air temperature sensor
4
2 3
11 10
9
M.20
6
5
16
8
13. Coolant temperature sensor
14. Air pressure sensor
15. Throttle position sensor
16. Spark plug
TC
7
H10111