Throttle Cable Adjustment; Throttle Control; Throttle Position Adjustment; Front Brake Control - Husqvarna TR 650 TERRA 2013 Workshop Manual

TR 650 TERRA 2013 - TR 650 STRADA 2013
4
1
2 mm
(0,8 in.)
3
4
2
2
SETTINGS AND ADJUSTMENTS

Throttle cable adjustment

To check the correct adjustment of the throttle control cable, operate as follows:
- remove the reservoir and the filter box as outlined in the relevant sections;
- turn throttle twistgrip (1) and make sure that there is a clearance of approx.
2 mm
2 mm (0.08 in);
(0,8 in.)
- if this does not work, unlock the check nut (2);
- work on the nut (3) until you have about 2 mm clearance (0.08 in.);
- tighten check nut (2).
- reassemble all parts, in the reverse order compared to disassembly.
When throttle control cables (4) are replaced, adjust new cables as previously
H11667
explained.
2
H11668

Throttle control

1
The throttle twistgrip (1) is located on the right-hand side of the handlebar:

Throttle position adjustment

The position of the control on the handlebar can be adjusted by loosening the
two retaining screws (2).
2
H11669

Front brake control

The brake control lever (1) is located on the right-hand side of the handlebar.

Position adjustment

The position of the control on the handlebar can be adjusted by loosening the
1
two retaining screws (2).
A stop switch, during the braking action, causes the stop light on the tail light
to come on.
H11670
Operation with damaged throttle cable could result in an unsafe
riding condition.
Do not forget to tighten the screws (2) after adjusting.
After adjustment, turn the handlebar as far as possible to the right
and make sure that the lever does not touch the bodywork
Do not forget to tighten the screws (2) after adjusting.
D.5
Workshop Manual Ed. 09-2012