Digital Instrument, Warning Lights (Te) - Husqvarna 2013 TC 250R Workshop Manual

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
2
Workshop Manual Ed. 07-2012
ELECTRICAL SYSTEM
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA

Digital instrument, warning lights (TE)

1
3
The motorcycle is equipped with a digital instrument; on the instrument are
located 3 warning lights too: high beam, blinkers and fuel reserve.
1- BLUE warning light "HIGH BEAM"
2- GREEN warning light "BLINKERS"
3- ORANGE warning light "Fuel reserve"
The dashboard is activated only after the engine has been started.
A
NOTES:
H11415
- Every time the engine is started, the dashboard shows the SW version for the
first 2 seconds; after the check routine, the dashboard shows the last planned
function.
- A few seconds after the engine has been turned off, the dashboard is deac-
tivated.
- To select the instrument functions and to set to zero the functions, use the
SCROLL knob (A).
The instrument functions are the following, as shown below.
1- SPEED / ODO
2- SPEED / CLOCK
3- SPEED / TRIP
4- SPEED / CHRONO
5- SPEED / HOUR COUNTER (H)
1- SPEED / ODO
.................
H11416
1- SPEED (km/h or mph) / ODO
To change unit from kilometres to miles or miles to kilometres, proceed as follows:
1) with the engine off, press and hold the "SCROLL" button (A), then start the
2) press and hold the "SCROLL" button (A) until the symbol "Km/h" or "Mph
3) "Km/h" and "Mph Miles" are displayed in alternation - press the "SCROLL"
H11418
2- SPEED / CLOCK
A
- SPEED: motorcycle speedmaximum value: 299 Km/h o 299 mph;
- CLOCK: clock- Reading from 0:00 to 23:59:59;
To reset the clock, push the knob SCROLL (A) for more than 3 seconds in order
to increase the hours; release the knob and then, after 3 seconds, it is possible
to increase the minutes;
H11417
motorcycle to switch the instrument on.
Miles" is displayed, then release.
button (A) again while the desired unit of measurement is displayed.
M.36