General - Husqvarna 2013 TC 250R Workshop Manual

ENGINE REASSEMBLY
TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA

General

To reassemble, reverse the disassembly procedure. Any special instructions concerning reassembly
are expressly highlighted in the text. Always replace gaskets, oil seals, metal retainers, sealing washers made from
deformable material (copper, aluminium, fibre, etc.) and self-locking nuts after removal. Bearing specifications and dimensions have
been calculated for a certain life. We recommend replacing the bearings - especially those exposed to heavy loading - also considering
that checking them for wear is not an easy procedure. These recommendations are in addition to the dimensional checks of individual
components specified in the relevant section (see Section G "ENGINE OVERHAUL"). Cleaning all components thoroughly is critical to
reliability; bearings and any wear parts must be lubricated with engine oil before assembly. Screws, nuts and bolts must be tightened
to the specified torque (see pages H.4-H.15 and Section X "TIGHTENING TORQUE FIGURES").
Workshop Manual Ed. 07-2012
H.3