Changing The Fluid - Husqvarna 2013 TC 250R Workshop Manual

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
1A
Workshop Manual Ed. 07-2012
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA

Changing the fluid

Brake fluid should be checked and changed as per the "Maintenance Chart"
(see Section B), or earlier if contaminated with debris or water.
Do not change brake fluid in the rain or with a strong wind.
Use only fluid taken from a sealed container (DOT 4). Never reuse
brake fluid.
Avoid the ingress of contaminants such as dirt, water, etc. into the
reservoir.
Do not keep the reservoir open without its cover longer than nec-
essary; this would increase the risk of contamination.
Handle the fluid with care to avoid damage to painted parts.
Do not mix two brands of fluid. This would reduce boil-over point,
leading to loss of braking efficiency or degrading of rubber parts.
Replacement procedure is as follows:
- Take the rubber cap off the bleed valve (1) or (1A).
- Attach a clear plastic hose to the calliper bleed valve and place the other end
of the hose in a vessel.
H02297
BRAKES
L.8
H11125