Tail Light Replacement; Number Plate Bulb Replacement - Husqvarna 2013 TC 250R Workshop Manual

ELECTRICAL SYSTEM
TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA

Tail light replacement

Remove the tail light as follows:
- Loosen the two screws (1) under the rear mudguard.
- Extract the tail light (2) and disconnect the connector (3).
Once the tail light has been replaced, reverse the above procedure to reassemble.
Be careful not to overtighten the screws.

Number plate bulb replacement

- Loosen screw (1) and remove the number plate bulb (2) from the mudguard.
- Extract the bulb holder (3) with the bulb (4) from the housing.
- Pull the bulb (4) to detach it from bulb holder.
Once the tail light has been replaced, reverse the above procedure to reassemble.
H11134
Workshop Manual Ed. 07-2012
M.32