Husqvarna 2013 TC 250R Workshop Manual page 216

FRONT SUSPENSION
TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
Mount sealing rings and metal parts on the inner tube.
See the figure below for the installation sequence.
Note 1: Grease the edge of the sealing ring.
Note 2: Before sliding the sealing ring over the inner tube, cover tube edge with
plastic as shown in the figure.
This will avoid damage to the oil seal lip.
7
6 8
4
5
9
H06836
Fit metal bushing and washer to outer tube using an appropriate installer.
Fit the oil seal to the outer tube and push it home using an appropriate installer.
Make sure that the retaining ring groove inside the outer tube is fully visible.
H06837
Install the retaining ring.
Make sure that the retaining ring is fully seated in the groove inside the outer tube.
H06838
Workshop Manual Ed. 07-2012
I.12