The Http Redirect Add/Edit Screen - ZyXEL Communications UAG5100 User Manual

Figure 124 Configuration > Network > HTTP Redirect
The following table describes the labels in this screen.
Table 88 Configuration > Network > HTTP Redirect
LABEL
Add
Edit
Remove
Activate
Inactivate
#
Status
Name
Interface
Proxy Server
Port
Apply
Reset

17.2.1 The HTTP Redirect Add/Edit Screen

Click Network > HTTP Redirect to open the HTTP Redirect screen. Then click the Add icon or
select an entry and click the Edit icon to open the screen where you can configure the rule.
Figure 125 Network > HTTP Redirect > Add/Edit
Chapter 17 HTTP Redirect
DESCRIPTION
Click this to create a new entry.
Double-click an entry or select it and click Edit to open a screen where you can modify the
entry's settings.
To remove an entry, select it and click Remove. The UAG confirms you want to remove it
before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
This field is a sequential value, and it is not associated with a specific entry.
This icon is lit when the entry is active and dimmed when the entry is inactive.
This is the descriptive name of a rule.
This is the interface on which the request must be received.
This is the IP address of the proxy server.
This is the service port number used by the proxy server.
Click Apply to save your changes back to the UAG.
Click Reset to return the screen to its last-saved settings.
UAG5100 User's Guide
199