Printing The Printer Configuration And The Custom Sets; Printing And Clearing The Error Log, And Printing The Usage Metrics - IBM V03 Maintenance Information

8. Press the Cancel Print key to exit test mode.
Firmware Information
© Copyright 2002 IBM Corporation
Printer Machine Type and Model:
IBM P/N 75P0556: Base Code
Twinax SCS/IPDS Code

Printing the printer configuration and the custom sets

It is possible to store up to 8 custom configurations. The current printer configuration is shown on the operator
panel display in the upper right corner as <X>.
1. Load the printer with at least 22 in. (55.9 cm) of blank, fanfold forms in the same tractor the customer is using.
2. Press the Stop key to make the printer Not Ready (only the Power and Online LED's are lighted).
3. Press the Test key. The message 4247 OPERATOR TESTS appears, and the Online LED goes out.
4. Press the Micro
5. Press the Enter key, and wait for the configuration to print. To print a custom set:
a. Press the Micro
b. Press the Enter key and wait.
6. Press the Cancel Print key to exit test mode.

Printing and clearing the error log, and printing the usage metrics

Error Log: When a previously not logged error is encountered during printer operation, the Code Description is
entered into the Print Error Log and the Count is set to 00001. If the Code Description existed in the error log
from a previous posting, the Count is incriminated to the next higher number (see Figure 1).
key until the Printer Configuration test is displayed below 4247 OPERATOR TESTS.
key until Print Custom Sets is displayed.
4247-V03
Version 1.04
Version 6.01
98
Chapter 2. Diagnostics