IBM V03 Maintenance Information page 66

Table 14. MAP 0190: Forms feed problems (continued)
Step Questions/Actions
Make the following checks:
7.
a. Forms input and output stacking follows the
recommendations in Forms stacking recommendations.
b. Input forms are aligned to feed straight into the printer.
c. Input forms are not catching on the edge of the forms
carton.
d. Printer is properly positioned on the work surface (front
edge of the printer at the front edge of the work surface)
to provide unrestricted forms feed for front and rear push
forms paths.
e. Forms tension between the left and right tractors is
properly adjusted.
Left Margin Right Margin
Correct
f. Forms meet specifications described in Appendix B,
"Supplies, forms, paths, & environmental considerations".
g. Label forms meet specifications described in Appendix B,
"Supplies, forms, paths, & environmental considerations".
h. The environment meets the specifications described in
Environmental requirements.
Are the checks OK?
Left Margin Right Margin
Incorrect
Yes
Go to step 8.
No
Repair, as needed.
Run T&D in automatic mode
to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs). Continue with step
8.
Chapter 1. Diagnosing problems
66