IBM V03 Maintenance Information page 82

Table 16. Error messages (continued)
Message
069 DATA LOST
PRESS CANCEL PRINT
(Twinax interface only)
070 PRINTER BOARD CHANGED
VERIFY CONFIGURATION SETTINGS
089 RIBBON JAM
CHECK RIBBON
096 COVER OPEN
False Message
097 FUNCTION NOT AVAILABLE
MENU LOCKED
098 HOLD PRINT TIMEOUT
PRESS LOAD
(Coax interface only)
Description
Data lost.
Occurs when printer logic board or
microcode version has been replaced.
The ribbon motion sensor has detected an
error.
The cover open sensor has detected an
error.
The operator panel has been locked. This
means the Configuration Menu and Printer
Adjustments functions in the Test Menu
cannot be used.
003 FORMS EJECTED condition exceeded
60 seconds.
Action
Press Stop to clear the loss. Press Stop,
Cancel Print, then Start.
Verify printer configuration settings and
Custom Sets.
Turn off and then turn on the printer. If
message remains, see MAP 0160: Ribbon
feed and ribbon lift.
See MAP 0180: Top cover interlock.
Use the procedure in Unlocking and
locking printer configuration menu:
v If you need to use these functions.
v If the customer had the operator panel
locked. Always lock the operator panel
after completing your service procedures
by performing this procedure (see
Unlocking and locking printer
configuration menu).
Press Load.
Chapter 1. Diagnosing problems
82