Automatic Forms Thickness Adjust (Afta) Assembly - IBM V03 Maintenance Information

Automatic forms thickness adjust (AFTA) assembly

Perform the following procedures first:
1. Remove the Rear cover.
2. remove the Top cover asm..
Then:
AFTA
Motor
AFTA Motor
Screws
1. Record the AFTA indicator setting.
2. Disconnect the AFTA motor connector from the logic board.
3. Remove the cable from the cable retainers located in the rear
part of the mechanical asm.
Note the location of the connector and the cable path.
4. Remove the 2 AFTA motor screws and remove the motor.
If the motor is being removed only to access other parts, do
not disconnect the connector.
Chapter 5. Removals, service checks and adjustments
209