Rear Tractor Service Check - IBM V03 Maintenance Information

Rear tractor service check

Tractor drive gear in the drive position (engaged)
1. Turn off the printer.
2. Perform the Front tractor service check.
3. Remove the front tractor asm.
4. Inspect and clean the rear tractor pin feed belts and pins.
5. Remove the 2 screws and remove the rear tractor asm.
6. Observe the position of the rear tractor drive gear.
v In the engaged position, the tractor drive gear drives the
pin feed belts.
v In the idle position, the tractor drive gear does not drive
the pin feed belts.
7. Move the drive gear to the right (idle position).
8. Install the rear tractor into the printer.
9. Turn on the printer.
10. When the power-on sequence completes, turn off the printer.
11. Remove the rear tractor and look at the rear tractor drive
gear.
The gear should have moved left (drive position).
Chapter 5. Removals, service checks and adjustments
190