Encoder board
Attention:
This is an ESD sensitive area. See Electrostatic discharge (ESD) procedures before working with
parts that are sensitive to ESD.
Perform the following procedures first:
1. Remove the Rear cover.
2. Remove the Top cover asm..
3. Remove the Printhead.
Do not remove the printhead cables yet.
Then:
1. Attention:
Use care not to scratch the encoder strip in this
step.
Remove the 3 screws holding the encoder strip, and carefully
remove the encoder strip.
2. Disconnect the encoder cable from the encoder cable from
the printhead.
3. Remove the 2 screws holding the encoder asm.
Chapter 5. Removals, service checks and adjustments
218