IBM V03 Maintenance Information page 78

Table 16. Error messages (continued)
Message
014 INVALID FORMS SELECT/FORM
NAME
SELECT NEW DEVICE
(Message and form name alternate on the
first line of the display)
015 COMMUNICATIONS CHECK
CHECK CABLE
(Twinax interface only)
017 COMMUNICATIONS CHECK
(Twinax interface only)
020 FORMS JAMMED REAR TRACTOR
CLEAR JAM AND RELOAD FORMS
022 UNIT ADDRESS NOT RECEIVED
CHECK PRINTER ADDRESS
(Twinax interface only)
027 COMMUNICATIONS CHECK
CALL SYSTEM OPERATOR
(Coax interface only)
Description
Printer received a request for forms type
not supported in current forms
configuration.
No line sync detected on the twinax
interface.
Line parity error detected.
Jam detected at the rear tractor sensor.
Printer address not received from host or
invalid.
Enable Poll timeout. Printer not enabled in
60 seconds.
Action
Perform one of the following:
v Restart job.
v Cancel job.
v Select another source and restart the
job.
v Run the job with current source.
Refer to a 4247 User's Guide for more
detail.
Error automatically resets when line sync is
detected.
See "MAP 0121: Parallel with twinax or
coax attachments" on page 36.
See MAP 0121: Parallel with twinax or
coax attachments.
See MAP 0190: Form feed problems.
Check printer address for mismatch with
host. Set the correct address in printer
configuration.
See MAP 0121: Parallel with twinax or
coax attachments.
Check control unit.
See MAP 0121: Parallel with twinax or
coax attachments.
Chapter 1. Diagnosing problems
78