T&D12-Fanfold Form Printout Test - IBM V03 Maintenance Information

11. Press the Form Feed key to feed the paper back into the printer. The following message will display:
T&D11 Tear-Off Line Adjustment Test STORE YES ... NO
12. If the tear-off adjustment is correct, press the Line Feed key to store the tear-off position.
If the tear-off adjustment is not correct, press the Start key, and return to step 10 on page 114.
13. If the front tractor is installed, install the paper in the front tractor, and repeat the above procedure to adjust
the tear-off line for the front (second or optional).
14. If an error message is displayed, go to T&D error messages and actions.
15. The test completed successfully if the display advances to the next test number.
T&D12—Fanfold form printout test
Note: Use this test to check print quality, print wires, printhead wire shifter (18-wire printhead only), carrier
movement, paper feed, line skew, and bidirectional (vertical) alignment. See Print quality service checks for
symptoms, and see Table 24 for an example of a print sample.
1. Display:
T&D12 Fanfold Form Printout Test RUN TEST ? YES END NO
2. Press the Line Feed key.
3. If fanfold paper is not loaded, the printer will display:
T&D12 Fanfold Form Printout Test LOAD PAPER
4. Install fanfold paper in the rear tractor assembly (see Paper path nomenclature), and press the
Load/Eject key.
The print test will print, and the display will be:
T&D12 Fanfold Form Printout Test TEST RUNNING
5. When the print test is complete, the following message is displayed:
T&D12 Fanfold Form Printout Test TEAR & PRESS KEY
116
Chapter 2. Diagnostics