IBM V03 Maintenance Information page 43

DANGER
<1-13> Do not connect or disconnect a communication port, a teleport, or any other connector during an
electrical storm.
DANGER
<1-14> Switch off printer power and unplug the printer power cord before connecting or disconnecting a
communication port, a teleport, or other attachment connector.
Table 7. MAP 0123: External Network Print Server attachment
Step Questions/Actions
Tests with the communication line disconnected
1.
Work with each symptom in Reference table 5a, LED and
test page problems—External NPS.
Is the problem corrected?
Tests with the communication line connected
2.
Work with each symptom in Reference table 6a, network
server problems—External NPS before going to the next
item.
Is the problem corrected?
Yes
Run T&D in Automatic Mode
to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs).
Run T&D in Automatic Mode
to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs).
No
Go to step 2.
Refer to the Administrator's
Guide for your NPS unit:
S246-0111 for Ethernet
attachment
- or -
S246-0112 for token-ring
Chapter 1. Diagnosing problems
43