f. To end the T&D program, press the Form Feed (END) key.
g. The following message will be displayed:
........TEST & DIAGNOSTIC END........
h. Power off the printer, and remove the loop-back connector (if installed).
i. Single test mode description stops here.
10. Automatic Test Mode:
.....TEST AND DIAGNOSTIC STARTUP...... SINGLE YES ... NO
a. Press the Start key to select NO. You will be prompted by the display or the instructions in T&D
descriptions to press keys or install paper.
b. If an error is detected, an error message will be displayed.
TDXX FRU X(X) PRESS A KEY
c. For a description of error messages, go to T&D error messages and actions.
d. If all the tests run OK, the following message will be displayed:
........TEST & DIAGNOSTIC END........
e. To exit the T&D program, power off the printer, and remove the loop-back connector (if installed).
T&D descriptions
1. If an error message is displayed during the T&D program, note the error information.
TDXX FRU X(X) PRESS A KEY
2. Press any of the keys.
3. The following message will be displayed:
COMMAND REPT SKIP INIT
4. To repeat the last test, press the Line Feed key to select REPT.
103
Chapter 2. Diagnostics