IBM V03 Maintenance Information page 69

Table 14. MAP 0190: Forms feed problems (continued)
Step Questions/Actions
Perform the AFTA service check.
13.
Go to "Main paper drive check and adjustment" on page 166.
Is the service check OK?
Perform the tractor assembly service check (see Tractor
14.
asm. service checks).
Is the service check OK?
This is a 099 message. Check for customer operating errors.
15.
Was the customer performing a PARK operation?
Yes
Replace the upper feed roller
if worn rollers are suspected.
(This procedure is complete.)
You have completed this
procedure.
Tear off the forms in the area
between the printhead and the
tear bar.
Complete the Park operation.
Inform the customer that
forms must be torn off at the
tear bar before he confirms
the Park operation.
The 099 message occurred
because the printer could not
completely back the forms up
onto the tractor.
No
Repair, as needed.
Run T&D in automatic mode
to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs).
Repair as needed.
Run T&D in automatic mode
to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs).
Go to step 16.
Chapter 1. Diagnosing problems
69