IBM V03 Maintenance Information page 47

Table 9. MAP 0131: Paper path sensor (continued)
Step Questions/Actions
4. 1. Remove the forms.
2. Run T&D07 to tune the sensors (see Running the test
and diagnostic (T&D) programs).
3. Turn off the printer
4. Load forms.
5. Close the top cover.
6. Turn on the printer.
7. After the printer is completely powered on (approximately
20 seconds), press the Stop key to make the printer Not
Ready.
8. Press the Load/Eject key
Is there a false paper path sensor message?
Yes
Run T&D15 and verify correct
sensor operation. If not OK:
v Install a new logic board
(see Logic board).
- or -
v Install a new sensor cable
assembly (see Sensor
cable assembly).
Run T&D in automatic mode
to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs).
No
Run T&D in automatic mode
to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs).
Chapter 1. Diagnosing problems
47