IBM V03 Maintenance Information page 128

Table 20. T&D error messages and actions (continued)
Error Message Description
TD 12 FRU 0 18 Thermal sense
failure
TD 13 FRU 1 X Operator panel
failure
TD (**) FRU3 11 Paper sense failure 1. Clear paper jam.
TD (**) FRU 2 12 Ribbon sense
failure
TD (**) FRU 2 13 Carriage sense
failure
TD (**) FRU 2 14 AFTA failure
Action
1. Replace the printhead (see Printhead).
2. Replace the logic board (see Logic board).
3. Install new printhead cables.
1. This error can occur if the cover is not opened or
closed in less than 10 seconds. Run T&D13 again
to verify the problem.
2. See MAP 0180: Top cover interlock.
2. See Paper path service checks.
3. Run T&D15 to verify sensor operation. If a sensor is
not operational:
a. Replace the logic board (see Logic board).
b. Replace the sensor cable assembly (see Sensor
cable assembly).
1. Replace the ribbon drive motor (see Ribbon drive
motor).
2. Replace the logic board (see Logic board).
3. Replace the sensor cable assembly (see Sensor
cable assembly).
1. See Printhead drive service check.
2. Replace the logic board (see Logic board).
3. Replace the encoder board and cable (see Encoder
board).
4. Replace the encoder strip (see Encoder board).
5. Replace the printhead cables.
1. See Standard AFTA service check and adjustment.
2. Replace the logic board (see Logic board).
3. Replace the AFTA motor assembly (see Automatic
forms thickness adjust (AFTA) assembly).
128
Chapter 2. Diagnostics