IBM V03 Maintenance Information page 71

Table 14. MAP 0190: Forms feed problems (continued)
Step Questions/Actions
A paper presence sensor failure can cause a or 099 forms
18.
jam message to display instead of an 001 End of Forms
message.
Did the printer fail to detect end of forms?
Yes
Run T&D15, including
performing a sensor tune, and
verify correct sensor
operation. If not OK:
v Install a new logic board
(see Logic board).
v If the printer is still failing
after the logic board has
been changed, install a new
sensor assembly cable (go
to Sensor cable assembly).
Run T&D in automatic mode
to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs).
No
Go to step 19.
Chapter 1. Diagnosing problems
71