Power Supply - IBM V03 Maintenance Information

Power supply

Green
Yellow Wire
Fan
Support
Logic Board
Connector
C
Carriage Motor
Fan Connector
Main Power
Switch
Power
Connector,
Screw, and
Clamp
Board Fan
Connector
Perform the following procedures first:
1. Remove the Rear cover.
2. Remove the Top cover asm..
3. Remove the "logic board and power supply metal protector."
Then:
1. Remove the following:
v Power supply cover.
v Power connector (slides up).
v Green/yellow ground-wire screw.
v Fan connectors.
v Fan support.
v Logic board connector.
2. Remove the power supply mounting screws.
Note the type and location of each screw.
3. Lift the rear of the board and pull to remove.
Installation notes
1. When installing the green/yellow ground wire, the second star
washer must be located between the wire lug and the frame.
Chapter 5. Removals, service checks and adjustments
230