IBM V03 Maintenance Information page 127

T&D error messages and actions
Table 20. T&D error messages and actions
Error Message Description
ERROR RAM RAM error
TEST
ATTACHMENT Coax card error
CARD IS NOT
COMPATIBLE
WITH PRINTER
BASE CODE
WAITING CODE Operator error
DOWNLOAD
USING PARALLEL
PORT
TD 1 FRU 5 X Microcode/Hardware
- or - Match Error
TD 1 FRU 4 X
TD 1 FRU 2 2 Microcode error
TD 2 FRU 1 X Operator panel
failure
TD 3 FRU 0 X (*) Parallel interface
failure
TD 4 FRU 0 X Microcode error
TD 08 FRU 0 X AFTA failure
Action
Replace the logic board (see Logic board).
Verify that the coax card is installed with the coax base
code.
Verify that you are using the Stop and Test keys at
power on to initiate test and diagnostics
Replace the logic board (see Logic board.
Replace the logic board (see Logic board.
1. This error can occur if a key is not pressed in less
than 10 seconds. Run T&D02 again to verify the
problem.
2. Replace the operator panel (see Operator panel.
3. Replace the logic board (see Logic board).
4. Replace the operator panel cable.
Replace the logic board (see Logic board).
Replace the logic board (see Logic board).
1. See Standard AFTA service check and adjustment.
2. Replace the logic board (see Logic board).
127
Chapter 2. Diagnostics