IBM V03 Maintenance Information page 67

Table 14. MAP 0190: Forms feed problems (continued)
Step Questions/Actions
Make the following checks:
8.
v Inspect the condition of the paper bail plastic shield and
lower plastic shield. Ensure that the shields are firmly
attached.
Note: If you suspect lower plastic shield damage, remove
the screws to remove the plastic shield, and inspect it for
damage.
Shield
v Locate and remove any paper debris, label debris, or
label adhesive from the forms path.
Are these checks OK?
Yes
Go to step 9.
No
Repair, as needed.
Run T&D in automatic mode
to verify correct printer
operation (see Running the
test and diagnostic (T&D)
programs).
Chapter 1. Diagnosing problems
67