IBM V03 Maintenance Information page 181

Ribbon Lift
Motor Screws
Ribbon Lift Motor
Connector
Figure 19. Ribbon lift motor. (Viewed from top)
9. Ensure that the printhead cables are connected at both ends correctly.
10. Install the ribbon cartridge.
11. Perform T&D07 Verify that the ribbon is driven up and down by the ribbon lift motor, and pulled to the left by
the ribbon feed motor.
Note: If the ribbon lift motor lifts and lowers the ribbon during T&D11, but not during printing, replace the
logic board.
12. Return to the step that sent you here.
Printhead
Printhead
Cable
Chapter 5. Removals, service checks and adjustments
181