10.3 Setting In The Service Mode; Service's Choice - Konica Minolta Bizhub 162 Service Manual

Field Service Ver. 1.0 Apr. 2005

10.3 Setting in the Service Mode

10.3.1

SERVICE'S CHOICE

• SERVICE'S CHOICE is used to make the various service settings.
A. SHIPMENT DESTINATION
Purpose/Use To select the display of the fixed zoom ratios and paper sizes according to the applica-
ble marketing area.
Setting/ • The default setting is "METRIC."
Procedure
"METRIC"
INCH
JAPAN
CHINA
L. AMERICA (METRIC)
L. AMERICA (INCH)
B. MAINTENANCE COUNTER
Purpose/Use To enter an appropriate counter value (0 to 999999) as the tentative maintenance time.
Specify the setting on maintenance counter to "1" or "2": If the maintenance life is
reached, the maintenance call (M1) or Tech. Rep. call [Call Service (M1)] will appear.
Setting/ • The default setting is "0."
Procedure
"0" : Not counted
1 : Counted (The maintenance call display is given when the counter reaches 0.)
2 : Counted (The Tech. Rep. call display is given and the initiation of any new copy
✽
When "1" or "2" is selected, a screen will then appear to allow the counter value to be
entered.
NOTE
• The counter value is decremented until it reaches -999999 even after it has
counted 0.
C. IU LIFE STOP MODE
Purpose/Use When the Supplies Life Count. reaches the life value, the IU life will be detected. The
mode when the IU life is reached, is specified by this setting.
Setting/ • The default setting is "CONTINUOUS."
Procedure
"CONTINUOUS" : Enables copying. Maintenance call display is given.
STOP
NOTE
• The counter value is decremented until it reaches -999999 even after it has
counted 0. In this case, however, no image quality is guaranteed.
cycle is inhibited when the counter reaches 0.)
: Disables copying. Tech. Rep. call display is given and the initiation
of any new copy cycle is inhibited.
10. Service Mode
83