Konica Minolta Bizhub 162 Service Manual page 127

10. Service Mode
C. PM COUNTER
Purpose/Use • To display the count of the number of times each of different parts of the copier has
been used.
• The count should be cleared when the corresponding PM part is replaced.
Setting/ 1: BYPASS
Procedure 2: TRAY1
3: TRAY2
4: TRAY3 (should not be used)
5: TRAY4
6: TRAY5
7: ADF (FEED)
8: ADF (REVERSE)
9: IR
10: OZONE
11: CLEANING
• To clear the count, use "Clear Data" of the Service mode.
D. MAINTENANCE COUNTER
Purpose/Use To display the count of the Maintenance Counter.
When the counter reaches "0", maintenance call M1 or the Tech. Rep. call will appear,
according to the setting on maintenance counter of service choice.
☞
83
Setting/
• To clear the count, use "Clear Data" of the Service mode.
Procedure
E. SUPPLIES LIFE COUNT.
Purpose/Use To display the count of the Supplies Life Counter.
When the counter reaches "0", life 1 will be detected and maintenance call M2 will
appear.
The initial value is 40000, and the countdown system is used.
Setting/
• To clear the count, use "Clear Data" of the Service mode.
Procedure
F. APPLICATION COUNTER
Purpose/Use To display the count of the number of sheets of paper used for each of different applica-
tions.
Setting/ COPY PRINT: Number of copies made
Procedure FAX RX PRINT: (Only when Fax is used)
REPORT PRINT: (Only when Fax is used)
PC PRINT: Number of printed pages produced from PC
FAX TX PAGE: (Only when Fax is used)
MAIL TX PAGE: (Used only when SU-502 is mounted)
• To clear the count, use "Clear Data" of the Service mode.
98
Field Service Ver. 1.0 Apr. 2005